If a WiFi device is used, make sure your WiFi device has connected to the extender’s network, and not that of your router. If the WiFi extender is not set up, please connect to the default network (BrosTrend_EXT) of the WiFi extender. If the WiFi extender has been set up, connect your WiFi device to one of the extended networks. Make sure that the Mobile Data (if any) function is disabled.
If a computer is used, connect your computer to the WiFi extender via an Ethernet cable. In this way, your computer is connected to the WiFi extender physically. Make sure that your PC has no Internet connection during its setup.
Verify that re.brostrend.com or 192.168.0.254 is correctly entered in your browser.
When the PWR LED of the extender is solid on, press the RESET button on the extender with a needle, and release. The SIGNAL, WPS and PWR LED will flash once at the same time, then the PWR LED will turn back to solid blue.This indicates that your WiFi extender is reset to the default factory setting successfully.
The router may be encrypted with WEP or WPA/WPA (Enterprise) algorithm. Change the encryption type of the router to WPA-PSK or WPA2-PSK, and try scanning again.
Your main router is using a WiFi channel which is not supported by this WiFi extender. You need to login to the WEB Management Interface of your main router and change its WiFi channel to anyone which is listed below:
You can search the signal to see if the default network BrosTrend_EXTstill exists. If the default network BrosTrend_EXT exists, the WiFi extender is not set up.
Login the WEB Management Interface of the WiFi extender to see if the extended state is expanded.
You can put the WiFI extender and your router in the same room and observe if the SIGNAL LED gets solid blue.
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device
Choosing a selection results in a full page refresh.
Press the space key then arrow keys to make a selection.